User Tools

Site Tools


faq:setup_multiple_player_array

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
faq:setup_multiple_player_array [07/03/2019 12:21]
Pro-Player Plus created
faq:setup_multiple_player_array [07/03/2019 15:48] (current)
Pro-Player Plus
Line 1: Line 1:
-===== How do I setup multiple players in an array? ===== +===== Setup: ​How do I setup multiple players in an array? ===== 
-Coming soon...+This setup is more complicated than a single playerIt will require additional networking equipment to link all of the players together so they can communicate with each otherYou will need a gigabyte router or network switch and one Ethernet cable per deviceConnect each player to the router or switch using the Ethernet cables only after they have been configured properly. 
 + 
 +**NOTE:** there are two ways to configure #@PPP@# to run multiple units in sync; //​Master/​Chase//​ and //​Master/​Slave//​. 
 + 
 +In //​Master/​Slave//​ mode, only one player will be the //Master// while the other players will be //Slaves// to that //Master//. See the section [[:​faq:​mode_master_slave|Mode:​ How do I change a player from master mode to slave mode?]] on switching //Masters// to //​Slaves//​. 
 + 
 +In //​Master/​Chase//​ mode, each player needs to have a unique IP address, such as ''​192.168.168.1'',​ ''​192.168.168.2'',​ and so on. You must do this before connecting each player to the router or switch. 
 + 
 +{{ :​faq:​playerarraytopo.jpg?​direct&​600 |}}
faq/setup_multiple_player_array.1562174494.txt.gz · Last modified: 07/03/2019 12:21 by Pro-Player Plus